InSim.txt - Revision history

Flame CZE: 0.7F5 updates

2025-08-15T20:51:34Z

0.7F5 updates

Racon: Updated to 0.7F

2024-07-27T15:44:50Z

Updated to 0.7F

Show changes

Flame CZE at 10:49, 27 January 2024

2024-01-27T10:49:10Z

LakynVonLegendaus at 05:48, 24 December 2023

2023-12-24T05:48:18Z

Show changes

Flame CZE at 00:58, 2 December 2023

2023-12-02T00:58:07Z

Flame CZE at 00:32, 2 December 2023

2023-12-02T00:32:12Z

Van Sterberkt: Updated for version 0.7A, insim version 9

2021-12-22T13:42:02Z

Updated for version 0.7A, insim version 9

Van Sterberkt: /* Update 'updated for version 0.6V' */

2021-10-25T17:12:12Z

Update 'updated for version 0.6V'

Van Sterberkt: /* Contents */

2021-06-25T14:31:35Z

Contents

Show changes

LakynVonLegendaus: /* Contents */

2019-04-09T07:53:44Z

Contents

Show changes

@@ Line 28: / Line 28: @@
 // CHANGES
 // =======
 // 0.7F
@@ Line 322: / Line 326: @@
 	ISP_PLH,		// 66 - both ways		: set player handicaps
 	ISP_IPB,		// 67 - both ways		: set IP bans
 };
@@ Line 371: / Line 377: @@
 	SMALL_LCS,		//  9 - instruction		: set local car switches (flash, horn, siren)
 	SMALL_LCL,		// 10 - instruction		: set local car lights
 };
@@ Line 1,175: / Line 1,182: @@
 	byte	Sp3;
-	in_addr		BanIPs	[MAL_MAX_MODS]; // IP addresses, 0 to IPB_MAX_BANS (NumB)
+	in_addr		BanIPs	[IPB_MAX_BANS]; // IP addresses, 0 to IPB_MAX_BANS (NumB)
 };
@@ Line 2,387: / Line 2,394: @@
 // NOTE: OutGauge packets are not InSim packets and don't have a 4-byte header.

@@ Line 1: / Line 1: @@
 {{main article|InSim}}
-InSim.txt is a file found the games doc folder. It is a C++ header file that contains the definition for each packet as well as comments from Scawen as to how each packet should be used.
+'''InSim.txt''' is a file found the games doc folder. It is a C++ header file that contains the definition for each packet as well as comments from Scawen as to how each packet should be used.
-Here are the complete contents of InSim.txt as of 24 Dec 2023 (Patch 0.7E).
+Here are the complete contents of InSim.txt as of 24 Dec 2023 (patch {{LFS version|0.7E}}).
 <pre>#ifndef _ISPACKETS_H_

←Older revision		Revision as of 00:58, 2 December 2023
Line 2,815:		Line 2,815:
	//////		//////
	#endif</pre>		#endif</pre>
		+
		+	[[Category:InSim]]

←Older revision		Revision as of 00:32, 2 December 2023
Line 1:		Line 1:
	== Introduction ==		== Introduction ==
		+
		+	{{main article\|InSim}}

	InSim.txt is a file found the games doc folder. It is a C++ header file that contains the definition for each packet as well as comments from Scawen as to how each packet should be used.		InSim.txt is a file found the games doc folder. It is a C++ header file that contains the definition for each packet as well as comments from Scawen as to how each packet should be used.

@@ Line 5: / Line 5: @@
 == Contents ==
-Here are the complete contents of InSim.txt as of 25 Jun 2021 (Patch 0.6V).
+Here are the complete contents of InSim.txt as of 22 Dec 2021 (Patch 0.7A).
 <pre>#ifndef _ISPACKETS_H_
@@ Line 22: / Line 22: @@
-// INSIM VERSION NUMBER (updated for version 0.6V)
+// INSIM VERSION NUMBER (updated for version 0.7A)
 // ====================
-const int INSIM_VERSION = 8;
+const int INSIM_VERSION = 9;
 // CHANGES
 // =======
 // Version 0.6V
@@ Line 45: / Line 53: @@
 // IS_SPX Fuel200 : fuel remaining
 // IS_LAP Fuel200 : fuel remaining
 // Version 0.6T (INSIM_VERSION increased to 8)
@@ Line 303: / Line 310: @@
 	ISP_CSC,		// 63 - info			: car state changed
 	ISP_CIM,		// 64 - info			: connection's interface mode
 };
@@ Line 334: / Line 342: @@
 	TINY_AXM,		// 25 - info request	: send IS_AXM packets for the entire layout
 	TINY_SLC,		// 26 - info request	: send IS_SLC packets for all connections
 };
@@ Line 508: / Line 517: @@
 	byte	QualMins;
 	byte	RaceLaps;		// see "RaceLaps" near the top of this document
-	byte	Spare2;
+	byte	Sp2;
-	byte	Spare3;
+	byte	ServerStatus;	// 0 = unknown / 1 = success / > 1 = fail
 	char	Track[6];		// short name for track e.g. FE2R
@@ Line 1,054: / Line 1,063: @@
 // NOTE: If a new guest joins and does have a car selected then an IS_SLC will be sent
 struct IS_CIM // Conn Interface Mode
@@ Line 1,594: / Line 1,625: @@
 // Player flags
-#define PIF_SWAPSIDE		1
+#define PIF_LEFTSIDE		1
 #define PIF_RESERVED_2		2
 #define PIF_RESERVED_4		4
@@ Line 1,651: / Line 1,682: @@
 // Passengers byte
-// bit 0 female
+// bit 0 front male
-// bit 1 front
+// bit 1 front female
-// bit 2 female
+// bit 2 rear left male
-// bit 3 rear left
+// bit 3 rear left female
-// bit 4 female
+// bit 4 rear middle male
-// bit 5 rear middle
+// bit 5 rear middle female
-// bit 6 female
+// bit 6 rear right male
-// bit 7 rear right
+// bit 7 rear right female
@@ Line 1,788: / Line 1,819: @@
 // IS_NLP - compact, all cars in 1 variable sized packet
-// IS_MCI - detailed, max 8 cars per variable sized packet
+// IS_MCI - detailed, max 16 cars per variable sized packet
 // To receive IS_NLP or IS_MCI packets at a specified interval:
@@ Line 1,804: / Line 1,835: @@
 	byte	Position;	// current race position: 0 = unknown, 1 = leader, etc...
 };
 struct IS_NLP // Node and Lap Packet - variable size
@@ Line 1,812: / Line 1,845: @@
 	byte	NumP;		// number of players in race
-	NodeLap	Info[40];	// node and lap of each player, 1 to 40 of these (NumP)
+	NodeLap	Info[NLP_MAX_CARS];	// node and lap of each player, 1 to NLP_MAX_CARS (NumP)
 };
@@ Line 1,847: / Line 1,880: @@
 // NOTE 3) AngVel  : 0 = no change in heading,    8192 = 180 degrees per second anticlockwise
-struct IS_MCI // Multi Car Info - if more than 8 in race then more than one of these is sent
+const int MCI_MAX_CARS = 16;
+{
 	byte	Size;		// 4 + NumC * 28
@@ Line 1,854: / Line 1,889: @@
 	byte	NumC;		// number of valid CompCar structs in this packet
-	CompCar	Info[8];	// car info for each player, 1 to 8 of these (NumC)
+	CompCar	Info[MCI_MAX_CARS]; // car info for each player, 1 to MCI_MAX_CARS (NumC)
 };
@@ Line 2,099: / Line 2,134: @@
 // You can also get (TTC_SEL) or set (PMO_SELECTION) the current editor selection.
 struct IS_AXM // AutoX Multiple objects - variable size
@@ Line 2,112: / Line 2,149: @@
 	byte	Sp3;
-	ObjectInfo	Info[30];	// info about each object, 0 to 30 of these
+	ObjectInfo	Info[AXM_MAX_OBJECTS]; // info about each object, 0 to AXM_MAX_OBJECTS (NumO)
 };

←Older revision		Revision as of 17:12, 25 October 2021
Line 22:		Line 22:


−	// INSIM VERSION NUMBER (updated for version 0.6T)	+	// INSIM VERSION NUMBER (updated for version 0.6V)
	// ====================		// ====================