Difference between revisions of "LFS Editor/Guides/Steering Wheel"
From LFS Manual
< LFS Editor | Guides
Jump to navigationJump to search| Line 4: | Line 4: | ||
| Enter the [[Modeller|modeller]]. | | Enter the [[Modeller|modeller]]. | ||
| Switch to any 2D view (e.g. front view by clicking the {{old button|f|#00ff00}} button in the [[LFS Editor/User Interface#Viewports|viewport controls]] at the bottom right, or pressing the {{key press|F}} key. | | Switch to any 2D view (e.g. front view by clicking the {{old button|f|#00ff00}} button in the [[LFS Editor/User Interface#Viewports|viewport controls]] at the bottom right, or pressing the {{key press|F}} key. | ||
| − | | Click the {{old button|point}} button at the top to enter [[LFS Editor/Modeller/Point Mode|Point Mode]]. | + | | Click the {{old button|point}} button at the top to enter,or pressing the {{key press|3}} key. [[LFS Editor/Modeller/Point Mode|Point Mode]]. |
| − | | And click {{old button|new point|#a1ffa1}} and then click on the left side {{old button|create circle|#fbec5d}}. | + | | And click {{old button|new point|#a1ffa1}}and then click on the left side {{old button|create circle|#fbec5d}}. |
| Drag the circle you created to the left/right side. | | Drag the circle you created to the left/right side. | ||
| On the left {{old button|excl|#a1a1ff}} open Click Ctrl+ on the first point you created. | | On the left {{old button|excl|#a1a1ff}} open Click Ctrl+ on the first point you created. | ||
Revision as of 15:39, 22 September 2024
Creating a Steering Wheel
- 1 Enter the modeller.
- 2 Switch to any 2D view (e.g. front view by clicking the f button in the viewport controls at the bottom right, or pressing the F key.
- 3 Click the point button at the top to enter,or pressing the 3 key. Point Mode.
- 4 And click new pointand then click on the left side create circle.
- 5 Drag the circle you created to the left/right side.
- 6 On the left excl open Click Ctrl+ on the first point you created.
- 7 Switch to any 2D view (e.g. top view by clicking the T button in the viewport controls at the bottom right, or pressing the T key.
- 8 later clicklathe and set how many steps it will take and how many degrees it will rotate.
