Difference between revisions of "LFS Editor/Guides/Steering Wheel"

Latest revision as of 17:35, 22 September 2024

1 Enter the modeller.
2 Switch to any 2D view (e.g. front view by clicking the f button in the viewport controls at the bottom right, or pressing the F key).
3 Click the point button at the top (or press the 3 key) to enter Point Mode.
4 Click new point and then click create circle on the left side.
5 Drag the circle you created to the left/right side.
6
7 On the left excl open Click Ctrl+ on the first point you created.
8 Switch to any 2D view (e.g. top view by clicking the T button in the viewport controls at the bottom right, or pressing the T key.
9 Later, click lathe and set how many steps it will take and how many degrees it will rotate.

@@ Line 2: / Line 2: @@
 {{steps
+| Enter the [[Modeller|modeller]].
+| Switch to any 2D view (e.g. front view by clicking the {{old button|f|#00ff00}} button in the [[LFS Editor/User Interface#Viewports|viewport controls]] at the bottom right, or pressing the {{key press|F}} key).
+| Click the {{old button|point}} button at the top (or press the {{key press|3}} key) to enter [[LFS Editor/Modeller/Point Mode|Point Mode]].
+| Click {{old button|new point|#a1ffa1}} and then click {{old button|create circle|#fbec5d}} on the left side.
+| Drag the circle you created to the left/right side.
+| [[File:Drag Circle.gif|Drag circle]]
+| On the left {{old button|excl|#a1a1ff}} open Click Ctrl+ on the first point you created.
+| Switch to any 2D view (e.g. top view by clicking the {{old button|T|#00ff00}} button in the [[LFS Editor/User Interface#Viewports|viewport controls]] at the bottom right, or pressing the {{key press|T}} key.
+| Later, click {{old button|lathe|#a1ffa1}} and set how many steps it will take and how many degrees it will rotate.
+}}