Difference between revisions of "LFS Editor/Guides/Steering Wheel"
From LFS Manual
< LFS Editor | Guides
Jump to navigationJump to searchm |
|||
| Line 6: | Line 6: | ||
| Click the {{old button|point}} button at the top to enter, or pressing the {{key press|3}} key. [[LFS Editor/Modeller/Point Mode|Point Mode]]. | | Click the {{old button|point}} button at the top to enter, or pressing the {{key press|3}} key. [[LFS Editor/Modeller/Point Mode|Point Mode]]. | ||
| And click {{old button|new point|#a1ffa1}}and then click on the left side {{old button|create circle|#fbec5d}}. | | And click {{old button|new point|#a1ffa1}}and then click on the left side {{old button|create circle|#fbec5d}}. | ||
| − | | Drag the circle you created to the left/right side. | + | | Drag the circle you created to the left/right side.[[File:2024.09.22-19.01 1.gif|Drag circle]] |
| On the left {{old button|excl|#a1a1ff}} open Click Ctrl+ on the first point you created. | | On the left {{old button|excl|#a1a1ff}} open Click Ctrl+ on the first point you created. | ||
| Switch to any 2D view (e.g. top view by clicking the {{old button|T|#00ff00}} button in the [[LFS Editor/User Interface#Viewports|viewport controls]] at the bottom right, or pressing the {{key press|T}} key. | | Switch to any 2D view (e.g. top view by clicking the {{old button|T|#00ff00}} button in the [[LFS Editor/User Interface#Viewports|viewport controls]] at the bottom right, or pressing the {{key press|T}} key. | ||
| Later, click {{old button|lathe|#a1ffa1}} and set how many steps it will take and how many degrees it will rotate. | | Later, click {{old button|lathe|#a1ffa1}} and set how many steps it will take and how many degrees it will rotate. | ||
}} | }} | ||
Revision as of 16:13, 22 September 2024
Creating a Steering Wheel
- 1 Enter the modeller.
- 2 Switch to any 2D view (e.g. front view by clicking the f button in the viewport controls at the bottom right, or pressing the F key.
- 3 Click the point button at the top to enter, or pressing the 3 key. Point Mode.
- 4 And click new pointand then click on the left side create circle.
- 5 Drag the circle you created to the left/right side.
- 6 On the left excl open Click Ctrl+ on the first point you created.
- 7 Switch to any 2D view (e.g. top view by clicking the T button in the viewport controls at the bottom right, or pressing the T key.
- 8 Later, click lathe and set how many steps it will take and how many degrees it will rotate.
