LFS Editor/Guides/Steering Wheel

Creating a Steering Wheel

1. 1 Enter the modeller.
2. 2 Switch to any 2D view (e.g. front view by clicking the f button in the viewport controls at the bottom right, or pressing the F key.
3. 3 Click the point button at the top to enter, or pressing the 3 key. Point Mode.
4. 4 And click new pointand then click on the left side create circle.
5. 5 Drag the circle you created to the left/right side.
6. 6
7. 7 On the left excl open Click Ctrl+ on the first point you created.
8. 8 Switch to any 2D view (e.g. top view by clicking the T button in the viewport controls at the bottom right, or pressing the T key.
9. 9 Later, click lathe and set how many steps it will take and how many degrees it will rotate.