User:MandulAA/Sandbox

(0.7E temporary to-do)

LFS client

New keys

??

New commands

/status none|F9|F10|F11|F12|next|prev - sets status screen

E.g. /status next will cycle through the F9 to F12 status screens

(you could assign it to a CTRL+ or ALT+ key and then a wheel button)

/liveset and /pitins - do the functions of F11 and F12 menus

You can use operators:

= (set value)

+= (add to value)

-= (subtract from value)

Examples:

/pitins ftyre = r3 : change front tyres to R3 in pit stop

/pitins rtyre = super : change rear tyres to road super

/pitins fpressure = 1.1 : set front tyre pressure to 1.1 bar

/pitins fpressure += 0.1 : increase requested pressure by 0.1 bar

/pitins cancel : cancel all pit instructions

/pitins tyres always : change all tyres

/pitins tyres 20 : change tyres if wear > 20%

/liveset bbal 60 : set brake balance to 60%

/liveset rarb -= 0.1 : decrease rear ant-roll bar by 0.1

Available options for /pitins:

fuel, tyres, repair, symmetric

ftyre, fcamber_l, fpressure_l, fcamber_r, fpressure_r, fwing

rtyre, rcamber_l, rpressure_l, rcamber_r, rpressure_r, rwing

cancel, fcamber, fpressure, rcamber, rpressure

/pitins pressure commands can accept unit (psi/bar) (no unit = bar)

E.g. /pitins fpressure 30 psi

Available options for /liveset:

bbal, farb, rarb

Multiple commands on single line

Multiple commands can now be added on a single line which sometimes

can avoid the need for a script file, e.g. to set a button to

change tyres in pit stop, you could use a double command:

/pitins ftyre super /pitins rtyre super

NOTE: some commands cannot be followed by another command:

/say /echo /join /rcm /pass /msg /altf /ctrlf

others

/h_mass username X - set added mass for user's car

/h_tres username X - set restriction for user's car

/teamarrows=no/yes - arrows on non-race small map use name colour

lights

Side lights, low and high beam headlights are now supported

Text command /light (requires two parameters) to switch lights:

/light ind [off/left/right/all] - switch indicators/hazard lights

/light head [off/side/low/high/low_off/low_high/next/prev] - lights

/light [rfog/ffog/extra] [off/on/toggle] - switch fog/extra lights

/light all [off/on] - switch all switchable lights off/on at once

Key '3' now toggles between off & low beam like /light head low_off

SHIFT+3 goes through all headlight states like /light head next

Editor

Modeller hotkeys / shortcuts

CTRL+O: load main object

Keys for subob, point, tri, map, cutout, page modes:

CTRL+D: duplicate

CTRL+N: new

DELETE: delete

H: hide selected (points or triangles)

SHIFT+H: hide unselected

ALT+H: unhide all

E: extrude selected points (with trace enabled in point mode)

S: select selection's points / select connected triangles

CTRL+F: flip selected triangles (in tri mode)

CTRL+F: flip connected triangles (in point mode)

CTRL+I: invert selection (points or triangles)

ALT+M: Merge points (previously known as Fuse points)