InSim/Version History
From LFS Manual
Jump to navigationJump to searchHistory of all InSim versions. The primary source is the changelog in docs/InSim.txt.
| InSim | LFS | Incompatible changes |
|---|---|---|
| 1 | 0.3G | Initial version of the InSim system |
| ? | 0.5X | Allow up to eight TCP or UDP connections, new buttons system allowing better interface in InSim programs |
| 5 | 0.6B | Longer IS_MST, lap timing info added to IS_RST |
| 6 | 0.6H | IS_REO and IS_NLP increased in size to allow 40 drivers, ObjectInfo Zchar changed to Zbyte |
| 7 | 0.6M | Backward compatibility system by sending InSim version in IS_ISI, Zbyte added to CarContObject and IS_OBH, IS_MSO / IS_III / IS_ACR have variable size, IS_BFN to delete a range of buttons |
| 8 | 0.6T | New values PMO_POSITION and PMO_GET_Z for PMOAction and new values PMO_SELECTION_REAL, PMO_MOVE_MODIFY, PMO_AVOID_CHECK of PMOFlags in IS_AXM |
| 9 | 0.7A | New size byte for packets representing packet size / 4, IS_AXM maximum objects increased to 60, IS_MCI maximum cars increased to 16 |
0.7F5
26 January 2025
0.7F
27 July 2024
- IS_IPB / TINY_IPB - set / get list of IP bans
0.7E
17 December 2023
- License byte added to IS_NCI packet (after Language byte)
- IS_PLH packet sets handicaps for individual players
- TINY_PLH - request IS_PLH listing player handicaps
- SMALL_LCL - full control of lights including fog and extra lights
0.7A
16 December 2021
- INSIM_VERSION increased to 9
- New size byte for packets - now represents packet size / 4
- this allows much larger packets, up to 1020 bytes
- IS_AXM maximum objects increased to 60 (was 30) - see AXM_MAX_OBJECTS
- IS_MCI maximum cars increased to 16 (was 8) - see MCI_MAX_CARS
- IS_MAL / TINY_MAL - set / get list of mods allowed on host
0.6V
28 February 2021
- NLP / MCI minimum time interval reduced to 10 ms (was 40 ms)
- IS_CPP FOV can now be used in-car but not smoothed (0 = no change)
- IS_CPP Pos is now relative to "Centre view" not the user setting
- IS_RES TTime now indicates time since qualifying started
- IS_RES PLID is now zero if the player has left the race
- IS_NPL Config : setup configuration
- IS_NPL Fuel : initial fuel load
- IS_NPL RWAdj : tyre width reduction (rear)
- IS_NPL FWAdj : tyre width reduction (front)
- IS_PIT FuelAdd : fuel added
- IS_SPX Fuel200 : fuel remaining
- IS_LAP Fuel200 : fuel remaining
0.6T
7 July 2018
- INSIM_VERSION increased to 8
- New value PMO_POSITION for IS_AXM packet to report a blank position
- New packet IS_CIM reports a connection's interface mode
- New values TTC_SEL_START and TTC_SEL_STOP for IS_TTC
- New value PMO_GET_Z for IS_AXM packet to report Z values
- New values PMO_SELECTION_REAL, PMO_MOVE_MODIFY, PMO_AVOID_CHECK
0.6N
24 April 2016
- Added ISS_DIALOG and ISS_TEXT_ENTRY to the ISS state flags
- New packet SMALL_LCS - set local car switches (lights, horn, siren)
0.6M
13 February 2016
- INSIM_VERSION increased to 7
- Backward compatibility system - send INSIM_VERSION in the IS_ISI
- Older programs (that send zero) are assumed to require version 6
- New join request system enabled if ISF_REQ_JOIN is set in IS_ISI
- IS_JRR can also be used to reset a car at a specified location
- Packet IS_CSC to report changes in car state (currently start or stop)
- Zbyte added to CarContObject structure to report car's altitude
- Zbyte added to IS_OBH so the layout object can be identified
- IS_MSO / IS_III / IS_ACR message out packets now have variable size
- IS_BFN can now be used to delete a range of buttons with a single packet
- New packet IS_OCO can be used to override specific or all start lights
- New IS_AXM option PMO_SELECTION to set the current editor selection
- Added TTC_SEL to request an IS_AXM with layout editor selection
- Added TINY_AXM to request IS_AXM packets for the entire layout
- IS_SSH documentation updated as it is no longer only for bmp files
- New packet IS_UCO sends info about InSim checkpoints and circles
- New packet IS_SLC reports a connection's currently selected car
- Packet TINY_SLC to request an IS_SLC for all connections
- Added TINY_ALC and SMALL_ALC to get and set allowed cars (like /cars)
- Value 5 (out of bounds) added to the IS_HLV packet
0.6H
2 April 2015
- INSIM_VERSION increased to 6
- IS_REO and IS_NLP increased in size to allow 40 drivers
- ObjectInfo Zchar is now Zbyte - see layout file description
- ISP_NCI packet added to give host more info about new guest
0.6C
29 November 2012
- Small change to the in-game usage of IS_REO - only valid after SMALL_VTA
- Some more values (CPW / OOS / JOOS / HACK) added to the leave reasons
0.6B
17 July 2011
- INSIM_VERSION increased to 5
- Lap timing info added to IS_RST (Timing byte)
- NLP / MCI minimum time interval reduced to 40 ms (was 50 ms)
- TINY_VTC now cancels game votes even if the majority has not been reached
- IS_MTC (Msg To Connection) now has a variable length (up to 128 characters)
- IS_MTC can be sent to all (UCID = 255) and sound effect can be specified
- IS_CON reports contact between two cars (if ISF_CON is set)
- IS_OBH reports information about any object hit (if ISF_OBH is set)
- IS_HLV reports incidents that would violate HLVC (if ISF_HLV is set)
- IS_PLC sets allowed cars for individual players
- IS_AXM to add / remove / clear autocross objects
- IS_ACR reports successful or attempted admin commands
- OG_SHIFT and OG_CTRL (keys) bits added to OutGaugePack
- New IS_RIP option RIPOPT_FULL_PHYS to use full physics when searching
- ISS_SHIFTU_HIGH is no longer used (no high / low view distinction)
- FIX: Clutch axis / button was not reported from Controls screen
- FIX: TTime in IS_RIP was wrong in mid-joined Multiplayer Replays
- FIX: IS_BTN did not allow the documented limit of 240 characters
- FIX: OutGaugePack ID was always zero regardless of ID in cfg.txt
- FIX: InSim camera with vertical pitch would cause LFS to crash
0.5Z
7 February 2008